BISOPE series 5 General method for naming vibration measuring points mea...

BISOPE series 5-General method for naming vibration measuring points (measuring points)

------------------------------------------------------------ ----------------------------------------------

In order to effectively measure vibration and perform predictive maintenance, it is necessary to find and set the correct measurement point and store the measured data continuously. A defect in equipment is usually found at the point where vibration shows the highest amplitude, and this may have directionality or may be a point that directly expresses the cause. It is a diagnosis. However, the first starting point for this diagnosis is to name the measurement point, and we will check the internationally common naming method.

 

Measurement point selection rules

If data measurement points are marked on equipment, data are collected from the same location, so trend data has reliability first. The measuring points should be the same as those called on the instrument (route) or on the recording paper (computer file). For example, if the ‘horizontal direction of the motor half-load side’ was measured and saved by the measuring instrument, there would be a way to easily recognize this point and express it simply.

 

All copyright  korea CBM  written by BISOPE , vs72@naver.com, 070-4388-0415,  www.kCBM.kr

 

keyword

Vibration Sensor, Accelerometer, HVA, Accelerometer, Vibration Measurement Direction, Vibration Measurement Position, Horizontal, Axial, Inboard, Coupling, DE, NDE, Load Vibration